Wunderlich Reling pour topcase BMW - chromé

Wunderlich Reling pour topcase BMW - chromé

Numéro d´article 20570-003
Prix : 189,90 €
TVA 19% incluse, (frais d´envoi exclus)
Soon available again

L´objet de l´achat peut ne pas inclure les accessoires éventuellement photographiés.

Spécialement développé pour le topcase de la BMW R 1200 RT et BMW K 1200 GT à partir de 2006 (année de construction) et BMW K 1300 GT.

Solution élégante, mais aussi pratique pour le topcase d´origine. Pour pouvoir transporter encore plus de bagages, mais aussi tout ce qui ne doit pas forcement entrer dans le topcase : combinaison mouillée, gants etc.),

Caractéristiques :

  • fixations cachées robustes en quatre points,(douilles filetées dans le tube d´acier,
  • tube d´acier de précision sans soudures
  • excellentes finitions "Made in Germany",
  • fixations imperméables,
  • instructions et set de montage inclus,
  • montage simple.
Filename Filesize
12114-10621 1.55 MB Download

Commentaires des clients

Satisfaction Review by Marc
Évaluation
Ok (Posté le 26/06/17)
Satisfaction Review by Marc
Évaluation
Correspond descriptif et à mes attentes (Posté le 26/06/17)
Satisfaction Review by Marc
Évaluation
Correspond au descriptif et à mes attentes (Posté le 26/06/17)
Qualité et rapidité Review by Harrydl
Évaluation
Produits reçu dans dans un très court délai, et de très bonne qualité. (Posté le 01/06/17)
Installation could be made easier Review by Greg
Évaluation
I liked the look and quality of the rack for my R1200RT but the installation could be made easier. The drilling of the two front holes at the required angle is somewhat difficult and if not done properly, makes installing the screw close to impossible. An easy fix would be to redesign the front of the rack where these screws attach similar to the design of the rear screws- flat to the trunk rather than the angled approach. Though a nice design, I think a little function over form is in order. (Posté le 26/09/12)
Top Case Luggage Rack Install Review by Robert B Phelps
Évaluation
I enjoyed the benefit of having a good buddy who recently installed this rack. He came over had a couple pieces of advice, throw away the template and install the angled (front) legs first. He had followed the factory instructions for his installation and from that experience arrived at the conclusion that I should not. We carefully measured and triangulated until placing the rack in the right spot, drew pencil around the front, spring loaded center punch to mark for the drill, finished by drilling with angle to the rear. Loosely installed purchased 6x20mm bolts, lower and marked the rear, punched and drilled. Installed bolts in the rear and tightened it all up. Under 40 minutes invested including opening the box. I do recommend getting the longer 6mm x 20 mm bolts for the front and using the longer ones in the kit for the rear. I got the black powder coat, the finish is great and the rack looks great on the machine. I recommend this product. (Posté le 01/05/12)

Rédigez votre propre commentaire

Quelle note donneriez-vous à ce produit ? *

  5 étoiles 4 étoiles 3 étoiles 2 étoiles 1 étoile
Évaluation